2005 Saab 9-7X LinearFACTORY OEM SERVICE PROCEDURE

Computer/Integrating Systems Component Views

Fig 1: Lower Left Of The I/P
GM1488411Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Turn Signal/Hazard Flasher Module
2 Instrument Panel Harness
3 Data Link Connector (DLC)
4 Splice Pack SP205
Fig 2: Body Control Module (BCM) Component View
GM747629Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Body Control Module (BCM)
2 Fuse Block - Rear
3 Body Control Module Connectors C1 and C2
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.