Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Saab 9-5 Linear, AutomaticFACTORY OEM SERVICE PROCEDURE
Stabilizer DTCS
STABILIZER DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description |
|---|---|
| C0131 | Pressure Sensor Failure |
| C0141 | Pressure Increase Valve, Left - Incorrect |
| C0146 | Pressure Relief Valve Left - Incorrect |
| C0151 | Pressure Increase Valve Right - Incorrect |
| C0156 | Pressure Relief Valve Right - Incorrect |
| C0186 | Lateral Accelerator Sensor Faulty signal |
| C0196 | Yaw Rate Sensor Faulty Signal |
| C0252 | ABS and ESP Regulation |
| C0256 | Accelerator Position No Data, Bus From ECM. |
| C0551 | Control Module Not Programmed |
| C0710 | Steering Angle Sensor Faulty Signal |
| C1371 | Wheel Sensor Front Left Signal Incorrect |
| C1372 | Wheel Sensor Front Left Signal Incorrect |
| C1376 | Wheel Sensor Front Right Signal Incorrect |
| C1377 | Wheel Sensor Front Right No Signal |
| C1381 | Wheel Sensor Rear Left Signal Incorrect |
| C1382 | Wheel Sensor Rear Left No Signal |
| C1386 | Wheel Sensor Rear Right Signal Incorrect |
| C1387 | Wheel Sensor Rear Right No Signal |
| C1390 | Wheel Sensor Wrong Number of Teeth |
| C1532 | Battery Voltage Too Low |
| C1540 | Solenoid Valves Open Circuit |
| C1600 | General Bus Fault Short-Circuited or Short to B+/Short to Ground |
| C1605 | Control Module Fault |
| C1925 | No CAN Communication With ECM or TCM |
| C1926 | Accelerator Position No Data, Bus From ECM |
| C1927 | Engine Torque No Data, Bus From ECM |
| C1928 | Engine Torque No Data, Bus From ECM. |
| C1929 | No CAN Communication With Steering Angle Sensor |
| C1930 | Selected Gear Invalid Information, Bus From TCM |
| C2415 | Solenoid Valves Rear Left - Incorrect |
| C2450 | Solenoid Valves Front Left - Incorrect |
| C2455 | Solenoid Valves Front Right - Incorrect |
| C2465 | Pump Motor Defective |
| C2470 | Brake Light Switch Open Circuit |
| C2485 | Solenoid Valves Rear Right - Incorrect |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.