2005 Saab 9-5 Linear, AutomaticFACTORY OEM SERVICE PROCEDURE

Steering wheel angle sensor (657): Notes

Fig 1: Identifying Steering Wheel Angle Sensor (657)
G03864872Courtesy of SAAB-SCANIA OF AMERICA, INC.

The steering wheel angle sensor is located on the steering column between the steering wheel and the intermediate shaft. The sensor senses the angle of the steering wheel and is connected to the Pbus. The sensor provides the ESP control module with information on steering wheel angle.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.