Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2005 Saab 9-2X Linear, 253, AutomaticFACTORY OEM SERVICE PROCEDURE

Select Lever: Removal

Set the vehicle on a lift.

Disconnect negative cable from battery.

Set the select lever to the "N" range.

Lift-up the vehicle.

Remove the rear exhaust pipe and muffler.

Saab 9-2X 2.5i Linear
Saab 9-2X 2.0T Aero

Remove the heat shield cover. (If equipped)

Fig 1: Removing Heat Shield Cover

Courtesy of SAAB-SCANIA OF AMERICA, INC.

Disconnect the cable from select lever, and then remove the cable bracket.

Fig 2: Removing Cable Bracket

Courtesy of SAAB-SCANIA OF AMERICA, INC.

Adjusting nuts
Cable bracket

Lower the vehicle.

Remove the console box.

Disconnect the connectors, then remove the four bolts to take out the select lever assembly from the body.

Fig 3: Removing Console Box Bolts

Courtesy of SAAB-SCANIA OF AMERICA, INC.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.