2005 Saab 9-2X Linear, 253, AutomaticFACTORY OEM SERVICE PROCEDURE

Select Cable: Removal

Set the vehicle on a lift.

Set the select lever to "N" range.

Disconnect negative cable from battery.

Lift-up the vehicle.

Remove front, center, rear exhaust pipe and muffler. (Saab 9-2X 2.5i Linear)

Remove the center and rear exhaust pipes and muffler. (Saab 9-2X 2.0T Aero)

Remove the heat shield cover. (If equipped)

Fig 1: Removing Heat Shield Cover
G03873982Courtesy of SAAB-SCANIA OF AMERICA, INC.

Remove the snap pin and washer from range select lever.

Fig 2: Removing Snap Pin And Washer From Range Select Lever
G03873983Courtesy of SAAB-SCANIA OF AMERICA, INC.
  1. Range select lever
  2. Snap pin
  3. Select cable
  4. Clamp
  5. Washer

Remove the plate assembly from transmission case.

Fig 3: Removing Plate Assembly From Transmission Case
G03873984Courtesy of SAAB-SCANIA OF AMERICA, INC.
  1. Select cable
  2. Plate ASSY
  3. Clamp

Disconnect the cable from select lever, and then remove the cable bracket.

Fig 4: Removing Cable Bracket
G03873985Courtesy of SAAB-SCANIA OF AMERICA, INC.
  1. Adjusting nuts
  2. Cable bracket

Remove the select cable from plate assembly.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.