Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Saab 9-2X Linear, 253, AutomaticFACTORY OEM SERVICE PROCEDURE
Quick Lookups: Fluids
| FLUID CAPACITIES | |||||||
|---|---|---|---|---|---|---|---|
| Fluid Type | Application | Standard | Metric | Fluid Spec | Note | S/H | |
| Air Cond Compressor Oil | 4.90 OZS. | 0.14 L | PAG 100 | S | |||
| Air Cond Refrigerant | 1.00 LBS. | 0.45 KG | R-134a | S | |||
| Automatic Transmission Fluid | 10.00 QTS. | 9.46 L | Automatic Transmission Fluid DEXRON III | S | |||
| Brake Fluid | N/A | N/A | DOT 3 or DOT 4 Brake Fluid | DO NOT mix two different kinds or makes of fluids. | S | ||
| Engine Coolant | 2.5L Eng,Automatic Trans | 7.30 QTS. | 6.9 L | SAAB approved Antifreeze | S | ||
| Engine Oil | w/Filter | 4.20 QTS. | 3.97 L | API - SAE 5W-30 | You may use a synthetic motor oil if it displays the API Certification Seal, and it is the proper weight. | S | |
| Fuel Tank | 15.90 GALS. | 60.18 L | S | ||||
| Manual Transmission Fluid | 3.70 QTS. | 3.5 L | API - GL-5, SAE 75W-90 | S | |||
| Power Steering Fluid | 0.70 QTS. | 0.66 L | Automatic Transmission Fluid DEXRON III | S | |||
| Windshield Washer Fluid | N/A | N/A | Windshield Washer Fluid | If windshield washer fluid is not available use clean water. In areas where water freezes in winter, use an antifreeze type windshield washer fluid. | S | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.