2004 Saab 9-5 Linear, StandardFACTORY OEM SERVICE PROCEDURE

To fit

  1. Position the control module from above.
    Fig 1: Illustration For Steps 1 To 3
    G03732753Courtesy of SAAB-SCANIA OF AMERICA, INC.
  2. Fit the 2 control module retaining nuts.
  3. Spray the control module multi-connector with Kontakt 61 (part no. 30 04 520) and plug in the connector.
  4. Fit the protective cover on the control module.
  5. Fit the windscreen cover. Be careful with the bonnet release wire on the left-hand side.
    Fig 2: Illustration For Steps 5 To 9
    G03732754Courtesy of SAAB-SCANIA OF AMERICA, INC.
  6. Fit the rubber seal.
  7. Fasten the screw clips on the ends of the windscreen cover.
  8. Fit the rubber wiper spindle seals.
  9. Fit the nuts on the wiper spindles with the blanking-off washers on the nuts.
  10. Perform Measures after changing a control module.
  11. Reset immobilization as follows:
    • Connect Tech2 and turn the ignition to ON
    • Select Body and TWICE
    • Select Immobilization. After 10 seconds the immobilizer is programmed.
Chapter Navigation
Return to Chapter: Control Module
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.