2004 Saab 9-5 Linear, StandardFACTORY OEM SERVICE PROCEDURE

Control module inputs

Fig 1: Identifying Control Module Inputs
G03745782Courtesy of SAAB-SCANIA OF AMERICA, INC.
  • Current (+30 circuit) (1)
  • Current (+15 circuit) (20)
  • Ground (G30, G2).
  • Wheel sensors, front (298FL, 298FR)
  • Wheel sensors, rear (298RL, 298RR)
  • Brake light switch (29)
  • Diagnostic communication (445)
  • Switch, ESP (660)
  • Steering wheel angle sensor (657)
  • Yaw rate sensor, lateral acceleration sensor (658)
  • Brake pressure sensor (659)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.