Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Saab 9-5 Linear, AutomaticFACTORY OEM SERVICE PROCEDURE
Second code
02 = Year of manufacture (02 = 2001)
07 = Week of manufacture (calendar week)
CONNECTOR PIN CODE SPECIFICATION
| Number of connector pins on each connector (2 connectors) | 38 |
| Power supply (+30 circuit) | pin no. 33 (A) |
| Power supply (+15 circuit) | pin no. 31 (A) and 32 (A) |
| Main ground | pin no. 23 (A) and 32 (A) |
| P-Bus (+) | pin no. 25 (A) |
| P-Bus (-) | pin no. 26 (A) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.