Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Saab 9-5 Linear, AutomaticFACTORY OEM SERVICE PROCEDURE
Automatic Transmission DTCS
AUTOMATIC TRANSMISSION DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Definition |
|---|---|
| P0218 | Transmission Fluid - Temperature Has Been Too High |
| P0560 | Battery Voltage - Voltage Incorrect |
| P0602 | Control Module Not Programmed |
| P0605 | Internal Fault |
| P0703 | Brake Switch Status - Error Message From ECM |
| P0705 | Transmission Range Switch - Input Incorrect |
| P0711 | Oil Temperature - Range/Performance Malfunction |
| P0712 | Oil Temperature Oil Temperature - Short To Ground |
| P0713 | Oil Temperature Oil Temperature - Open Circuit/Short To B+ |
| P0717 | Input RPM - No Signal |
| P0722 | Output RPM - No Signal |
| P0725 | Engine RPM Signal - Incorrect |
| P0730 | Gear Function - Mechanical Fault |
| P0731 | Gear 1, Faulty Gear Ratio |
| P0732 | Gear 2, Faulty Gear Ratio |
| P0733 | Gear 3, Faulty Gear Ratio |
| P0734 | Gear 4, Faulty Gear Ratio |
| P0735 | Gear 5, Faulty Gear Ratio |
| P0736 | Reverse, Faulty Gear Ratio |
| P0743 | Solenoid Lock-Up - Open/Short To Ground Or Short To B+ |
| P0748 | Solenoid Pressure Regulation - Open/Short To Ground Or Short To B+ |
| P0753 | Solenoid S2 - Open/Short To Ground Or Short To B+ |
| P0758 | Solenoid S3 - Open/Short To Ground - Short To B+ |
| P0763 | Solenoid S4 - Open/Short To Ground - Short To B+ |
| P0768 | Solenoid S5 - Open/Short To Ground Or Short To B+ |
| P0773 | Solenoid S - Open/Short To Ground Or Short To B+ |
| P0780 | Shifting Time - Mechanical Fault |
| P0785 | Solenoid SLS - Open/Short to Ground Or Short to B+ |
| P0826 | Sentronic Signal From SID, Incorrect Signal |
| P1743 | Lock-Up - Mechanical Fault |
| P1803 | General Bus Fault |
| P1820 | Accelerator Pedal Position - Error Message From ECM |
| P1895 | Engine Torque - Error Message From ECM |
| P1921 | No bus data from ECM |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.