Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2004 Saab 9-5 Linear, AutomaticFACTORY OEM SERVICE PROCEDURE

Injectors (206)

Fig 1: Identifying Injectors (206)

Courtesy of SAAB-SCANIA OF AMERICA, INC.

INJECTORS DESCRIPTION

Location		On top of intake manifold
Part number (Bosch)		0280 156 023
Type		Bosch EV6 E, brown
Version		4-hole
Resistance at 20°C (68°F)	Ohm	15.95+/-0.8
Flow rating (at 3 bar fuel pressure)	ml/30 s	176 +/-7
Maximum permissible difference between injectors	ml	20

Chapter Navigation

Return to Chapter: Technical Data

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.