Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Saab 9-5 Linear, AutomaticFACTORY OEM SERVICE PROCEDURE
Connecting rods
CONNECTING RODS TECHNICAL SPECIFICATION
| Diameter at big-end | 56.000 - 56.019 mm |
| Gudgeon pin bushing, inside diameter (fitted) | 24.012 - 24.017 mm |
| Maximum difference in weight between connecting rod big-ends in the same engine | 6 g (0.21 oz.) |
| Length B235 Center-Center | 153 mm |
| Length B205 Center-Center | 159 mm |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
