Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Saab 9-5 Linear, AutomaticFACTORY OEM SERVICE PROCEDURE
General data
BALANCER SHAFT TECHNICAL DATA
| Diameter of balancer-shaft journal (inner) | 39.892 - 39.908 mm |
| Diameter of balancer-shaft bearing (inner) | 39.988 - 40.043 mm |
| Bearing clearance, journal bearing (inner) | 0.080 - 0.151 mm |
| Maximum permissible bearing clearance (inner) | 0.18 mm |
| Diameter of balancer-shaft journal (outer) | 19.947 - 19.960 mm |
| Diameter of balancer-shaft bearing (outer) | 20.000 - 20.021 mm |
| Bearing clearance, journal bearing (outer) | 0.040 - 0.074 mm |
| End float | 0.060 - 0.460 mm |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.