Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Saab 9-3 Linear, AutomaticFACTORY OEM SERVICE PROCEDURE
To remove
- Remove the fuel pump. See FUEL PUMP, TO REMOVEΒ .
- Detach the connector from the pump cover.
- Undo the lock on the cable terminals.
- Pry out the fuel level sensor cable terminal, pin no. 2 (grey cable), pin no. 3 (white cable), with cables from the connector. Use 85 80 151 KIT, CONNECTOR PIN REMOVAL TOOLΒ .
- Remove the fuel level sensor.
IMPORTANT:
Take care not to damage the fuel level sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
