2004 Saab 9-3 Linear, AutomaticFACTORY OEM SERVICE PROCEDURE

To fit

  1. Fit the spark plugs.

    Tightening torque 20 Nm (15 lbf ft)Β  .

    Fig 1: Illustration For Steps 1, 2
    G03707861Courtesy of SAAB-SCANIA OF AMERICA, INC.
  2. Fit the ignition coils.

    Tightening torque 8 Nm (6 lbf ft)Β  .

  3. Fit the cover over the ignition coils.
    Fig 2: Illustration For Steps 3
    G03707862Courtesy of SAAB-SCANIA OF AMERICA, INC.
  4. Remove the test cable and put back relay no. 8.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.