Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Saab 9-3 Linear, AutomaticFACTORY OEM SERVICE PROCEDURE
Main purpose
The primary function of the PDM is to:
- Read the status of the door lift buttons.
- Control and supply the window lift in the passenger door (with optional pinch protection function).
- Supply the passenger door mirror motor and mirror heating (with optional memory function and electrically operated retraction).
- Read the central locking button status and transmit the value on the bus.
- Supply the central locking system motor in the door, with or without theft security locking (TSL), and to read the status of the central locking system and the TSL and transmit the value on the bus.
- The control module also reads the door switch status via a direct connection but does not use the value. The connection is intended for future development.
- Supply the illumination of the door buttons.
- Supply the step in lighting which is mounted on the underside of the door
- The PDM is also included in the car's "immobilizing environment" and continuously transmits an ID number on the bus.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.