Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Main task
Simtec 71.6 primarily regulates:
- Engine torque
- Fuel injection
- Ignition
A number of sensors provide information to the control module, which processes the data with the help of matrices that are stored in the control module after optimization of the engine's function. Examples of such matrices are ignition status matrices, fuel matrices and mass airflow matrices.
Simtec 71.6 is SPS programmable.
The control module can be damaged by electrostatic discharges or a short-circuit in any control module output. So, great care must be taken when handling the control module during troubleshooting or the like.
Fuel injection is primarily regulated using the mass air flow sensor. There are substitute functions for all sensors except the crankshaft sensor.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.