Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Saab 9-3 Linear, AutomaticFACTORY OEM SERVICE PROCEDURE
To fit
- Fit the door module pressing it obliquely upward so that the clip engages.
- When changing the driver door module: Fit the door trim screw.
- When changing the driver door module: Affix the cell block with double-sided tape. The use of 16-30 20 807 is recommended.
- Make sure the door trim clips are in place and intact. Replace the clips if necessary.
- Fit the door trim.
- Cars with pinch protection: Perform Programming of the pinch protection. See ELECTRIC MOTOR FOR SUNROOF (WITH PINCH PROTECTION) .
- If the control module has been changed , perform Measures after changing the control module. See PROCEDURE AFTER CHANGING CONTROL MODULE .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.