Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Saab 9-3 Linear, AutomaticFACTORY OEM SERVICE PROCEDURE
To fit
WARNING:
Do not connect the control module before it is fitted.
- Fit the Airbag Control Module by inserting it between the center console's aluminum frame and the floor into its position. Tighten the screws that hold the Airbag Control Module.
Tightening torque 10 Nm (7 lbf ft)Β
IMPORTANT: Take care when plugging in the connector so as not to damage or press out the pins/sleeves in the connector. For further information regarding connectors, refer to CONNECTORS, HANDLING AND INSPECTIONΒ . - Fit the two connectors to the Airbag Control Module.
- Remove the wedge.
- Fit the front legroom adjuster screws on the center console's aluminum frame.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
