Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Saab 9-3 Vector, AutomaticFACTORY OEM SERVICE PROCEDURE
Control valve, bypass: Diagnostics
- If there is an open circuit or short circuit to ground, diagnostic trouble code P1658 will be generated.
- If there is a short circuit to B+, diagnostic trouble code P1659 will be generated.
- If the bypass valve fails to open during deceleration, diagnostic trouble code P1110 will be generated.
- In the event of an internal leak in the bypass valve, the current air mass/combustion will not reach the requested air mass/combustion.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.