2003 Saab 9-3 Vector, AutomaticFACTORY OEM SERVICE PROCEDURE

Control valve, bypass (605)

Fig 1: Identifying Control Valve, Bypass
G03576870Courtesy of SAAB-SCANIA OF AMERICA, INC.
TECHNICAL DATA - CONTROL VALVE, BYPASS

Location   In engine bay on bulkhead
Characteristics   Zero current closed
Resistance at 20°C (68°F) Ohms 40+/-5

When the solenoid valve is unenergized, the bypass valve control line is connected after the throttle.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.