2003 Saab 9-3 Vector, AutomaticFACTORY OEM SERVICE PROCEDURE

Test readings, rear left door module, (702RL): Remember: Notes

  • Observe the test criteria. Use common sense when assessing the test results.
  • Check first that the control module is receiving power and is grounded.
  • Then check all sensor inputs and signals from other systems.
  • Finally, check the control module outputs. Remember that the test readings are not a confirmation of whether the actuator is in working order.
  • If a test reading is incorrect, use the wiring diagram to locate the leads, connectors or components that need to be checked further.
  • Specified readings are for a calibrated Fluke 88/97.
  • Test readings % (+) and ms (+) indicate the signal pulse ratio and pulse width respectively. A scan tool with pulse ratio and pulse width measurement must be used. The sign indicates positive trigger pulse, TRIG+.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.