2003 Saab 9-3 Vector, AutomaticFACTORY OEM SERVICE PROCEDURE

To remove

  1. Ignition key in the position LOCK.
  2. Removing the passenger seat.
  3. Release the handbrake.
  4. Remove the center console's front side panel.
    Fig 1: Illustration For Step 4 And 5
    G03617149Courtesy of SAAB-SCANIA OF AMERICA, INC.
  5. Remove the center console's rear side panel.
  6. Remove the center console's rear cover.
  7. Dismantle the connector to the ignition switch.
  8. Remove the rear legroom adjuster screws on the center console's aluminum frame.
    Fig 2: Illustration For Step 7 To 9
    G03617150Courtesy of SAAB-SCANIA OF AMERICA, INC.
  9. Remove the front legroom adjuster screws on the center console's aluminum frame.
  10. Dismantle the screws that hold the Airbag Control Module.
    Fig 3: Illustration For Step 11 And 12
    G03617151Courtesy of SAAB-SCANIA OF AMERICA, INC.
  11. Drive in a wedge between the floor and the aluminum frame so that the aluminum frame is lifted about 2 cm.
    IMPORTANT: Take care when releasing the locking mechanism on the connector so as not to damage the connector. Pull the halves straight apart to avoid bending the pins. For further information regarding connectors, refer to CONNECTORS, HANDLING AND INSPECTIONΒ .
  12. Dismantle the Airbag Control Module's two connectors.
  13. Lift up and carefully move the Airbag Control Module out between the aluminum frame and the floor.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.