2003 Saab 9-3 Linear, AutomaticFACTORY OEM SERVICE PROCEDURE

Control module ground: Notes

The control module is grounded via pin 19 to grounding point G30.

The pump motor is grounded through pin 16 to grounding point G2.

Fig 1: Control Module Ground - Communication Diagram
G03578859Courtesy of SAAB-SCANIA OF AMERICA, INC.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.