Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Air mass control, basic function: Diagnostics
In principle, the air mass/combustion is the same as engine torque. Air mass control is therefore of great interest when diagnosing bad performance.
There is a special menu in the diagnostic tool from which values of interest can be read. The most important is the deviation between requested and current air mass/combustion.
The current value should always, sometimes after a short interruption, follow the requested value. If this is not the case a fault in the turbo function is possible.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.