2003 Saab 9-3 Arc, StandardFACTORY OEM SERVICE PROCEDURE

Connector M

COMPONENT FUNCTION

Pin (refers to the control module) Color Component / Function In / Out Measurement requirement. Measurement value Measure between
1 GN/WH Mass air flow sensor Out   5 V 1-47
6 GN/WH Level switch, engine oil Out   < 0.1 V 6-B-
8 GY Temperature sensor, coolant Out   2.9 V 8-45
9 BU Absolute pressure sensor In   1.75 V 9-B-
10 BK/GN Mass air flow sensor In   1.1 V 10-B-
11 GY Screen ground In   < 0.1 V 11-B-
13 PK Solenoid valve, charge air Out   5.5 V 13-B-
14 WH EGR Out   10.3 V 14-B-
19 OG/WH EGR In   4.4 V 19-B-
21 BK Temperature sensor, engine oil Out   4.1 V 21-33
22 GN/WH Intake air temperature In   2.2 V 22-46
23 BK Crankshaft sensor In Idling 1.6 V alternating current 23-35
24 GN/WH Pressure switch, engine oil Out Idling < 0.1 V B+ 24-B-
27   L-Terminal   Idling B+ < 0.5 V 27-B+
28 YE/BU Main relay Out   B+ 28-B+
29 PK Solenoid valve, engine shut-off Out   B+ 29-B-
33 BK Temperature sensor, engine oil In   4.1 V 33-21
34 BK Level sensor, fuel In   B+ 34-B+
35 YE Crankshaft sensor In Idling 1.6 V alternating current 35-23
39 BU/WH Power supply, Map Out   5 V 39-B-
42 PK Solenoid valve, engine shut-off Out   B+ 42-B-
43 BN/WH Solenoid valve, combustion circulation Out   5.3 V 43-B-
45 BK Temperature sensor, coolant In   2.9 V 45-8
46 BK Map, sensor ground In   5 V 46-39
47 BU Mass air flow sensor, reference ground In   5 V 47-1
48 GY Level sensor, fuel Out   1 V 48-34
Fig 1: Identifying Connector M
G03617252Courtesy of SAAB-SCANIA OF AMERICA, INC.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.