Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB20029-3 SE, 2D CONVERTIBLE, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMTRIONIC T7 FUEL CONTROL SYSTEMTECHNICAL DESCRIPTIONMULTIPLICATIVE ADAPTATIONDIAGNOSTICS
2002 Saab 9-3 SE, 2D Convertible, Automatic
Multiplicative adaptation: Diagnostics
2002 Saab 9-3 SE, 2D Convertible, AutomaticSECTION Diagnostics
- If the correction factor reaches 1.25 (25%), diagnostic trouble code P0171 will be generated.
The fault can be caused by:
- Low fuel pressure.
- Defective mass air flow sensor.
- If the correction factor reaches 0.75 (-25%), diagnostic trouble code P0172 will be generated.
The fault can be caused by:
- Air leak between the compressor and the throttle.
- Defective mass air flow sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.