Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSAAB20029-3 SE, 2D CONVERTIBLE, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMTRIONIC T7 FUEL CONTROL SYSTEMADJUSTMENT-REPLACEMENTIGNITION DISCHARGE MODULETO REMOVE

2002 Saab 9-3 SE, 2D Convertible, Automatic

To remove

2002 Saab 9-3 SE, 2D Convertible, AutomaticSECTION To remove

Fig 1: Illustration For Steps 1-3

Courtesy of SAAB-SCANIA OF AMERICA, INC.

Unplug the 10-pin ignition discharge module connector.
Remove the 4 screws.
Lift up the module.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.