2001 Saab 9-3 Base, 2D Hatchback, AutomaticFACTORY OEM SERVICE PROCEDURE

To remove

IMPORTANT: Great cleanliness must be observed when working on the fuel rail and injectors. Wash valves, fuel rail and intake manifold and clean them with compressed air.
  1. Remove the engine cover.
    Fig 1: Illustration For Step 1-2-3
    G03503741Courtesy of SAAB-SCANIA OF AMERICA, INC.
  2. Remove the fuel pump fuse no. 32 while the engine is running. Turn off the ignition once the engine has stopped.

    Refit fuel pump fuse no. 32.

  3. Undo the fuel connections to the fuel rail with the special tool, part no. 83 95 261.

    Wipe up excess fuel with a rag.

  4. Detach the crankcase ventilation hoses.
    Fig 2: Illustration For Step 4-5-6
    G03503742Courtesy of SAAB-SCANIA OF AMERICA, INC.
  5. Remove the dipstick and filler pipe and plug the pipe.
  6. Remove the cover on the throttle disc. Detach the accelerator wire from the throttle spindle. Remove the accelerator wire and holder and bend to one side.
  7. Undo the cable channel, 3 screws.
    Fig 3: Illustration For Step 7
    G03503743Courtesy of SAAB-SCANIA OF AMERICA, INC.
  8. Unplug the injector connectors and place the cable channel to one side.
    Fig 4: Illustration For Step 8-9-10-11-12-13
    G03503744Courtesy of SAAB-SCANIA OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.