Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Saab 9-3 Base, 2D Hatchback, AutomaticFACTORY OEM SERVICE PROCEDURE
Transaxle Specifications
TRANSAXLE SPECIFICATIONS
| Application | In. (mm) | |
|---|---|---|
| Differential Assembly | ||
| Pinion Gear Backlash | .002-.006 (.05-.15) | |
| Input Shaft End Play | 005-.035 (.37-.90) | |
| Oil Pump Bushing | ||
| Diameter | 1.500-1.501 (38.11-38.14) | |
| Wear Limit | 1.503 (38.18) | |
| Oil Pump Gear Side Clearance | ||
| Drive Gear | .0001-.0120 (.004-.298) | |
| Driven Gear | .003-.006 (.08-.15) | |
| Oil Pump Thrust Clearance | ||
| Standard | .001-.002 (.03-.05) | |
| Wear Limit | .004 (.10) | |
| Piston Stroke | ||
| 2nd Brake Clutch | .045-.073 (1.14-1.86) | |
| 2nd Coast Clutch | .029-.056 (.76-1.44) | |
| Direct Clutch | .059-.074 (1.52-1.89) | |
| Forward Clutch | .059-.074 (1.52-1.89) | |
| Low/Reverse Clutch | .069-.100 (1.75-2.55) | |
| Underdrive Clutch | .059-.074 (1.52-1.89) | |
| Planetary Gear Bushing | ||
| Specified Clearance | 1.181-1.182 (30.00-30.80) | |
| Service Limit | 1.184 (30.08) | |
| Sun Gear Bushing | ||
| Specified Clearance | .846-.848 (21.50-21.53) | |
| Service Limit | .850 (21.58) | |
| Stator Shaft Bushing | ||
| Diameter | .846-.848 (21.50-21.53) | |
| Wear Limit | .850 (21.58) | |
| Underdrive Sun Gear Bushing | ||
| Specified Clearance | .846-.848 (21.50-21.53) | |
| Service Limit | .850 (21.58) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
