2000 Saab 9-3 Base, 2D Hatchback, AutomaticFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Cooler Line Bolt 26 (35)
Drain Plug 17-40 (23-55)
Oil Pan Bolt 22 (30)
Park/Neutral Position Switch Lever Nut 18 (25)
Ring Gear Bolt 66-76 (90-103)
TFT Protector Bolt 15-22 (20-29)
Transaxle Case Bolt 17-26 (23-35)
Underdrive Brake Band Anchor Bolt 100-149 (133-200)
Valve Body Cover Bolt 18 (25)
INCH Lbs. (N.m)Β 
Accumulator Piston Cover Bolt 71-106 (8-12)
Input Shaft Speed Sensor Bolt 4-7 (35-62)
Lube Apply Clamp Bolt 35-62 (4-7)
Oil Filter Bolt 35-62 (4-7)
Oil Reserver Bolt 35-62 (4-7)
Park/Neutral Position Switch Bolt 53-71 (6-8)
Solenoid-To-Valve Body Bolt 6-7 (53-62)
Stator Support-To-Oil Pump 5-mm Bolt 6-7 (53-62)
Stator Support-To-Oil Pump 6-mm Bolt 89-124 (10-14)
Underdrive Brake Accumulator Bracket Bolt 71-106 (8-12)
Valve Body Bolt 62 (7)
Valve Body Suction Cover Bolt 62 (7)
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.