2000 Saab 9-3 Base, 2D Hatchback, AutomaticFACTORY OEM SERVICE PROCEDURE

Automatic Trans: Overhaul: Identification: Notes

Transaxle can be identified by identification plate attached to top of transaxle case. See Fig 1 . Identification plate contains transaxle model, year of manufacture and transaxle part number.

Fig 1: Locating Transaxle Identification Plate Information (Saab Shown; Daewoo Is Similar)
G95E21158Courtesy of SAAB-SCANIA OF AMERICA, INC.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.