2000 Saab 9-3 Base, 2D Convertible, StandardFACTORY OEM SERVICE PROCEDURE

To remove

WARNING: This page is about a different car, the 2002 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rim around the indicator display.
  2. Fig 1: Illustration For Steps 1-4
    G03530811Courtesy of SAAB-SCANIA OF AMERICA, INC.
  3. Carefully press in the 4 catches and lift up the indicator display.
  4. Press out the WINTER button from the indicator display.
  5. Move the protective tubing from the soldered joint on the centre wire and unsolder the wiring.
    NOTE: Protect the indicator display when soldering
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.