Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Saab 9000 CS, AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Steering Column Bolts | 15 (21) | |
| Steering Column Lower Nuts (9000 Series) | ||
| Green Chromatid Nuts | 11-15 (15-21) | |
| Standard Nuts | 14-19 (20-26) | |
| Steering Column Shaft Clamp Bolt | 20-25 (27-34) | |
| Steering Wheel Nut | ||
| 900 Series | 22 (30) | |
| 9000 Series | 21 (27) | |
| "U" Joint Lock Bolt | 17-22 (23-30) | |
| INCH Lbs. (N.m) | ||
| Air Bag Module Screw | 48-60 (5.0-7.0) | |
| Safety Cable Nut | 8-18 (1.0-1.5) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.