1994 Saab 900 CommemorativeFACTORY OEM SERVICE PROCEDURE

Ported EGR Valve

Warm engine to operating temperature. Increase engine speed to 1900 RPM on non-turbo engines or 2600 RPM on turbo engines. EGR valve should open. Disconnect vacuum hose (upper hose on EGR valve with 2 hoses) from EGR valve. Apply vacuum. Engine should idle rough or idle speed should drop.

Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.