Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Saab 900 CommemorativeFACTORY OEM SERVICE PROCEDURE
Trouble Code Definition (9000 Series Turbo)
DIAGNOSTIC CODE - TRIONIC SMFI (9000 SERIES TURBO)
| Code | Fault |
|---|---|
| P0105 | MAP Sensor |
| P0106 | MAP Sensor, Range/Performance Fault |
| P0107 | MAP Sensor, Signal Too Low |
| P0108 | MAP Sensor, Signal Too High |
| P0110 | IAT Sensor |
| P0112 | IAT Sensor Signal Too Low |
| P0113 | IAT Sensor Signal Too High |
| P0115 | ECT Sensor |
| P0117 | ECT Sensor Signal Too Low |
| P0118 | ECT Sensor Signal Too High |
| P0120 | TPS Sensor |
| P0122 | TPS Sensor Signal Too Low |
| P0123 | TPS Sensor Signal Too High |
| P0130 | O2 Sensor |
| P0135 | O2 Sensor Preheating Faulty |
| P1130 | O2 Sensor Preheating Current High |
| P1135 | Front O2 Sensor Preheating Current Low |
| P0170 | Fuel/Air Mixture Adaptation Fault |
| P0171 | Fuel/Air Mixture Lean |
| P0172 | Fuel/Air Mixture Rich |
| P1322 | Engine RPM |
| P0325 | Knock Sensor |
| P0335 | Crankshaft Position Sensor |
| P0443 | EVAP Valve Control Circuit |
| P1444 | EVAP Valve Current High |
| P1445 | EVAP Valve Current Low |
| P0500 | Speed Sensor |
| P0501 | Speed Sensor Malfunction |
| P0502 | Speed Sensor Signal Too Low |
| P0505 | Idling Control, IAC Valve |
| P1500 | Battery Voltage |
| P0605 | Internal Monitoring Function |
| P1651 | Internal Monitoring Function, RAM Fault |
| P1652 | Internal Monitoring Function, ROM Fault |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
