Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Saab 9000 S, AutomaticFACTORY OEM SERVICE PROCEDURE
Transmission Range Switch
NOTE:
AIC valve receives a signal from transmission range switch. DRIVE light will glow if system is working properly.
- If system is not working properly, check fuse No. 13 on 900 Series or fuse No. 9 on 9000 Series.
- With ignition on, check for battery voltage at White wire at switch, located at base of transmission selector lever. If no voltage is present, repair White wire back to fuse panel.
- Set transmission selector lever, in turn, to PARK and NEUTRAL positions. With ignition on, ensure no voltage appears at Orange wire on switch with lever in either position. With lever in all other positions, battery voltage should appear at Orange wire. If voltage is as specified, go to next step. Replace switch if it does not meet specification.
- Connect DVOM to pin No. 30 (Orange wire) at fuel injection ECU. Battery voltage should appear with switch in all positions but Park or Neutral. Repair Orange wire between switch and ECU if voltage does not appear.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
