Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Deceleration Fuel Cut-Off System: Operation
Deceleration system relay is activated only when coolant temperature is above 113°F (45°C), time relay is activated and engine speed exceeds 1400-1750 RPM. When throttle switch closes, system will operate until engine speed decreases below 1375F75 RPM.
During system operation, airflow is directed through by-pass hose and vacuum valve instead of passing the airflow sensor plate. Airflow sensor plate then closes which cuts off fuel supply to cylinders. See Fig 1 .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.