1982 Saab 900 S, 2D Hatchback, Standard TransFACTORY OEM SERVICE PROCEDURE

Deceleration Fuel Cut-Off System: Operation

Deceleration system relay is activated when coolant temperature is above 113Β°F (45Β°C), relay switch is in rest position and engine speed exceeds 1575 RPM. When throttle switch closes, system will operate until engine speed decreases to 1375 RPM.

During system operation, flow of air, which normally passes air flow sensor plate, is led through a hose and a vacuum valve by-passing mixture control unit. This results in air flow sensor plate not lifting which cuts off fuel to cylinders.

Fig 1: Saab Deceleration Fuel Cut-Off System
G09323318Courtesy of SAAB-SCANIA OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.