Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1985 Renault Sportwagon AutomaticFACTORY OEM SERVICE PROCEDURE
Ignition System: Overhaul: Disassembly
- Remove distributor cap, rotor, and plastic protector. Remove screw in the side of distributor. Pull upward on electrical connector to remove it from distributor housing. Remove 2 screws securing magnetic pick-up coil. See Figure.
- Lift out pick-up coil assembly. Remove reluctor, vacuum advance unit, and magnetic coil carrier. Remove drive pinion from distributor shaft. Pull shaft and centrifugal advance mechanism from housing.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.