Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1985 Renault Fuego AutomaticFACTORY OEM SERVICE PROCEDURE
Miscellaneous Components
MISCELLANEOUS COMPONENTS LOCATION
| Component | Location | |
|---|---|---|
| Auxiliary Relay Panel | Under left side of dash. | |
| Battery | ||
| Turbo Models | In storage compartment in right rear luggage area. | |
| Except Turbo Models | In lower left front corner of engine compartment. | |
| Circuit Breakers | ||
| A/C | On A/C blower assembly behind radio. | |
| Auxiliary Cooling Fan Motor | Behind right headlight (or intercooler on Turbo). | |
| Main Cool. Fan Motor | Behind right headlight (or intercooler on Turbo). | |
| Power Door Lock | Behind left console panel on steering column bracket. | |
| Sunroof Motor | In front panel of sunroof. | |
| Cruise Control Governor/Computer | On left upper side of automatic transmission. See Figure . | |
| Diagnostic Connectors | ||
| A/T | On right side of bellhousing. | |
| Engine | On firewall behind engine. | |
| Fuel Injection | On right front strut tower. | |
| Fuse/Relay Panel | Under dash to left of steering column. See Figure . | |
| Keyless Entry Receiver | Behind dash insert to left of steering wheel. | |
| Oil Level Indicator Module | On back of instrument panel. | |
| Rear Wiper Circuit Breaker | In rear wiper motor. | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
