1978 Renault R17FACTORY OEM SERVICE PROCEDURE

Federal Models

  1. Disconnect vacuum hose at deceleration valve and reconnect it to throttle plate opener on intake manifold.
  2. Warm engine to normal operating temperature. Increase engine speed to 2500 RPM, then let it decrease gradually.
  3. Check fast idle speed being held by throttle plate opener. It should be 1800-2000 RPM. If not, adjust by turning screw in end of throttle plate opener.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.