2021 Porsche Macan BaseFACTORY OEM SERVICE PROCEDURE

Programming Central Computer Data Update

NOTIFICATION 

Voltage drop 

  • Irreparable damage to control unit 
  • Damage to control unit 
  • Fault entries in the control unit 
  • Control unit programming/coding is aborted 
  • Malfunctions in the control unit, even during programming 
    1. → Switch off ignition before disconnecting the control unit.
    2. → Make sure that the power supply is not interrupted during programming/coding.
    3. → Connect the battery charger with at least > current 90 A  to the vehicle battery.

Information 

The procedure described here must only  be used if:

  • There is a Technical Information  (TI) or Symptom-based repair instructions  (SY) relating to the customer complaint
  • The central computer was replaced. 
  • The vehicle is assigned to a campaign  that involves carrying out a corresponding software update

The programming code and the approved software part number can be found in the specified documents.

Damage to the control unit cannot be ruled out if the software is used by other vehicles.

Information 

The PIWIS Tester  instructions take precedence since the description may be different with later Tester releases.

The procedure described here has been structured in general terms. Different text or additional information may appear on the PIWIS Tester. 

  1. Insert SD card containing the vehicle-specific software data into the SD card slot on the centre console.
    G15162397Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    SD card slot

  2. Select the vehicle type if required.
  3. Select the PCM  control unit in the overview  . Press F12 to continue. The message "Create Vehicle Analysis Log (VAL)?" appears. Press F11 to continue.
  4. Maintenance/repairs  must now be selected.
  5. Select Install software update. 
    1. 5.1  Read and follow the instructions and information on the Tester.
    2. 5.2  Perform software update according to menu guidance.
  6. Connect the Tester to the vehicle and start it. Switch on ignition.
  7. If fitted: Code CD/DVD autochanger.
    1. 7.1  Select CD/DVD autochanger. 
    2. 7.2 Coding/programming  must be selected.
    3. 7.3 Automatic coding  must now be selected. Press F12 to continue.
  8. If fitted: Code the amplifier.
    1. 8.1  Select Amplifier. 
    2. 8.2 Coding/programming  must be selected.
    3. 8.3 Automatic coding  must now be selected. Press F12 to continue.
  9. Read out the fault memory  , correct faults that are stored if necessary and clear the fault memory.
  10. Exit the diagnostic application. Switch off ignition. Disconnect the Tester from the vehicle.
  11. Remove SD card from the SD card slot on the centre console.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.