Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Porsche Cayenne BaseFACTORY OEM SERVICE PROCEDURE
69 Occupant Protection/Personal Protection -- 92A Cayenne
- WM 691119 Removing And Installing Front Three-Point Belt
- WM 691219 Removing And Installing Rear Three-Point Belt
- WM 696419 Removing And Installing Rear Side Airbag
- WM 691301 Checking Seat Belts
- WM 692419 Removing And Installing Front Seat-Belt Buckle
- WM 692519 Removing And Installing Rear Seat-Belt Buckle
- WM 693619 Removing And Installing Adjustment Fitting (Seat Belt Height Adjuster)
- WM 695119 Removing And Installing Airbag Sensor
- WM 695319 Removing And Installing Triggering Unit For Airbag
- WM 695355 Replacing Triggering Unit For Airbag
- WM 695355 Replacing Triggering Unit
- WM 695619 Removing And Installing Seat Occupancy Detection
- WM 695719 Removing And Installing Switch For Airbag
- WM 695819 Removing And Installing Driver's Airbag Unit
- WM 695919 Removing And Installing Passenger's Airbag Unit
- WM 696119 Removing And Installing Front Pressure Sensor
- WM 696319 Removing And Installing Side Airbag
- WM 696319 Removing And Installing Front Side Airbag
- WM 696619 Removing And Installing Head Airbag Unit
- WM 696819 Removing And Installing Occupant Detection Control Unit
- WM 696855 Replacing Occupant Detection Control Unit
- WM 697819 Removing And Installing Knee Airbag On Driver's Side
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.