Programming and Relearning

WM 966225 Teaching remote control

Teaching remote control

Information

If an additional hand-held transmitter is to be taught, for example, all original keys/remote controls must also be used and taught.

If a new hand-held transmitter is taught for a vehicle, the Teach Enable Code (TEC), Transponder password and Transponder Secret Key specified in IPAS must be entered.

You can get the codes from IPAS or from your importer by specifying the vehicle identification number.

During programming, it is essential to guarantee the power supply for the Porsche System tester. It is essential to connect a battery charger with a current rating of at least 40 A to the vehicle battery.

The Porsche System Tester instructions take precedence and in the event of a discrepancy these are the instructions that must be followed. Deviations may occur with later software versions.

The procedure described here has been structured generally, different text or additions may appear in the Porsche System Tester.

Information

- Only new hand-held transmitters or those already adapted to the immobiliser system on the vehicle can be taught.

- Hand-held transmitters that are already adapted are overwritten, and so all hand-held transmitters that will later be used on the vehicle must be taught.

- Teaching of keys is protected over a time period. Once this time has elapsed, teaching is aborted.

1. Ignition off. Connect the Porsche System Tester to the vehicle and start the System Tester. Select vehicle type.
2. Switch on hazard warning light; this will activate CAN and ensure that the KESSY control unit is identified.
3. Select PAS control unit and press >>.
4. Select Teaching function menu and press >>.
5. Select Teach keys menu and press >>.
6. Enter the Teach Enable Code TEC from IPAS and press >>. Then press F7 to confirm your entry.
7. Enter the Number of keys and press >>. Then confirm your entry by pressing F7.
8. Enter the Transponder password and press >>. Then confirm your entry by pressing F7.
9. Enter the Transponder Secret Key and press >>. Then confirm your entry by pressing F7.
10. The Tester displays the following prompt: Insert key 1 >> , Insert key 2 >> , etc. until the relevant number of keys is reached.
11. Observe Tester information regarding Synchronisation of keys, insert key and press the Lock button on the key for at least 5 seconds when instructed to do so by the Tester.
12. Wait 5 seconds before switching on the ignition. Switch on the ignition, read out the fault memory of all control units, and erase them if necessary.
13. Start the engine using each of the keys one after the other. Remote controls have now been taught.