2008 Porsche Cayenne Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS LOCATION

Component Location
Climatronic Man In center console. See Figure.
Climatronic 2+2 Control Unit (Front) In center console.
Climatronic 2+2 Control Unit (Left/Right) In center console.
Climatronic 2+2 Control Unit (Rear) In center console.
Comfort Systems Control Unit (Rear) Right rear cargo area.
CU Airbag Under center console. See Figure.
CU Air Suspension Ride - Height Control Right rear wheel housing. See Figure.
CU Axle - Differential Lock Left rear of vehicle. See Figure.
CU Center Differential Lock Under front passenger's seat. See Figure.
CU Gateway Right end of dash. See Figure.
CU Headlight (Left/Right) Behind respective headlight assemblies. See Figure.
CU KESSY Left center of dash. See Figure.
CU Motor Right rear of engine compartment. See Figure.
CU On Board Comp. Network Left side of dash. See Figure.
CU Parking Assistant Left rear cargo area. See Figure.
CU Rear Right rear wheel housing. See Figure.
CU Seat Memory (Left/Right) Under respective front seat. See Figure.
CU Stabilizer Decoupling Left rear of vehicle. See Figure.
CU Stationary Heater Left rear corner of engine compartment. See Figure.
CU Telephone Under front passenger's seat. See Figure.
CU Trailer Over right rear wheel housing. See Figure.
CU Weight Recognition Under front passenger seat. See Figure.
CU Wiper Left rear of engine compartment. See Figure.
DME Motor Control Unit In engine compartment.
Panorama Roof System Control Unit Front center of roof.
PCM 2.1 Middle of instrument panel.
PSM Control Unit Right rear of engine compartment.
Ride-Height Control Control Unit Over right rear wheelwell.
Tiptronic Control Unit Under right front seat.
Tire Pressure Control Unit Behind left end of dash.
Transmission Under front passenger's seat. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.