Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Porsche Boxster Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Wheels, Tires, Alignment
- 44 Wheels and Tires/Tire pressure - as of MY 2005 (All Models)
- 44 Adjustment values for suspension alignment - as of MY 2005 (All Models)
- 44 05 19 Removing and installing wheel - as of MY 2005 (All Models)
- 44 05 94 Balancing/optimizing wheels - as of MY 2005 (All Models)
- Tools
- Balancing/optimizing wheels
- General
- Explanation of terms
- Balancing/optimizing wheels
- Further to 1: Fitting the Tire on the rim
- Further to 2A: Measuring radial force variations
- Further to 2B: Stationary balancing with optimization of rolling smoothness
- Further to 3: Fitting the wheel on the vehicle
- Balancing weights
- Attaching the balance stick-on weights
- 44 12 02 Checking disc wheels - as of MY 2005 (All Models)
- 44 32 19 Removing and installing wheel electronics - as of MY 2005 (All Models)
- 44 34 19 Removing and installing Tire pressure monitoring system control module - as of MY 2005 (All Models)
- 44 38 19 Removing and installing Tire pressure monitoring system antenna - as of MY 2005 (All Models)
- 44 40 19 Fitting Tires for vehicles with and without Tire Pressure Monitoring (TPM) - as of MY 2005 (All Models)
- 44 95 03 Suspension alignment, complete - as of MY 2005 (All Models)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.