Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Porsche Cayenne BaseFACTORY OEM SERVICE PROCEDURE
Glazing, Window Control
- 64 12 19 Removing and installing windscreen - as of MY 2003 (All Models)
- 64 12 IN General information on removing car windows - as of MY 2003 (All Models)
- 64 40 19 Removing and installing front door window - as of MY 2003 (All Models)
- 64 48 19 Removing and installing front window channel seal - as of MY 2003 (All Models)
- 64 52 19 Removing and installing front power windows - as of MY 2003 (All Models)
- 64 54 19 Removing and installing front power window motor - as of MY 2003 (All Models)
- 64 58 19 Removing and installing switch for front power windows - as of MY 2003 (All Models)
- 64 60 19 Removing and installing rear door window - as of MY 2003 (All Models)
- 64 62 19 Removing and installing microswitch for rear window release - as of MY 2003 (All Models)
- 64 66 19 Removing and installing bottom section for rear window release - as of MY 2003 (All Models)
- 64 67 19 Removing and installing pneumatic spring for rear window - as of MY 2003 (All Models)
- 64 68 19 Removing and installing the rear window shaft seal - as of MY 2003 (All Models)
- 64 71 19 Removing and installing rear power windows - as of MY 2003 (All Models)
- 64 75 19 Removing and installing side window - as of MY 2003 (All Models)
- 64 86 19 Removing and installing rear window - as of MY 2003 (All Models)
- 64 90 19 Removing and installing rear window seal - as of MY 2003 (All Models)
- 64 93 19 Removing and installing relay for heated windows - as of MY 2003 (All Models)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.