Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Porsche Boxster Base, AutomaticFACTORY OEM SERVICE PROCEDURE
O2 Sensor Circuit
Diagnostic conditions
- Battery positive voltage between 10 V and 16 V
- Oxygen sensor heating switched on for at least 120 seconds
- Exhaust temperature between 200°C and 800°C
Possible cause of fault
- Oxygen sensor faulty
Affected pins
DME control module connector II, pin 8 and oxygen sensor jack, bank 2, pin 3
DME control module connector II, pin 14 and oxygen sensor jack, bank 2, pin 4
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.