2004 Porsche Boxster Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Removing Current Distributor

Fig 1: Identifying Current Distributor Removal Sequence
G03092869Courtesy of PORSCHE OF NORTH AMERICA, INC.
CURRENT DISTRIBUTOR REMOVAL SEQUENCE

No. Procedure Instructions
  Disconnect battery Remove the battery cover and the cover of the right radiator tank.
Removing and installing cowl panel cover. Refer to REMOVING AND INSTALLING COWL PANEL COVER .
Refer to WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY .
Disconnect and cover the ground terminal on the battery
1 Current distributor fastening Pull off the covering cap -1-2-3- (1)
2 Cover in passenger's footwell Unscrew both plastic screws -4-5- (1)
3 Lowering the current distributor Disconnect the tie-wrap -7-6-6-A-arrow- (1)
4 Opening the current distributor Disengage the lock -arrow-8-green-red-blue- (1)
5 Disconnecting the connection lines Mark the connection lines -C-C-B-9- (1)
(1) Fig 1
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.